To speed the clock up, move the pendulum disk up by turning the adjustment nut to the right (See figure 17). Grandfather Clocks: Quick Setup Guide - The Clock Depot Pull the pendulum to the far left or right and release. Check the weights occasionally to ensure that they are still tightly assembled. Sunday, Nov. 7, 2021: Daylight saving time ends at 2 a.m. Set clocks back one hour. Grandfather The three weights provide power to the hour strike (left weight), time (center weight), and chime melody (right weight). Do not permit the cable to overlap on the drum. How to Fix a Cuckoo Clock That Chimes at the Wrong Hour Care should be taken whenever you move your clock to insure that all accessory parts such as the pendulum and weights are removed and packed properly to prevent damage. If the clock stops the moon dial will also stop and can. You can find it on the outside of the shipping carton or on the back of the door, on the back or top of the Grandfather Clock, inside the top back corner or inside the Grandfather Clock above the back of the dial. Selection of the chime sequencing feature or one of the three chime melodies is done with the selector lever. If not, a small adjustment is usually all that is necessary for your clock to keep accurate time. Most grandfather clocks have a provision for changing the minute hand position to the dial so it can achieve this. ADJUST LEVELERS FORMAXIMUM STABILITY AND PROPER ALIGNMENT. The plastic clip may be turned or tape may be removed permanently. eval(targ+".location='"+selObj.options[selObj.selectedIndex].value+"'"); clocks andgrandfather Example: If the last full moon was 3 days ago, rotate the moon dial clockwise 3 lunar days so that the moon is centered at lunar day 18 on the lunar arch. Keep an eye on your clock over the next day to make sure the time is still right and the pendulum is still swinging. How do you set a battery operated grandfather clock? When we change our clocks. CHICOPEE, Mass. You should never need to reset the phase of the moon if you keep your clock wound. NEVER wind a cable drive movement without weights installed. Hi Bree, You need to follow the instructions on the following page: This year, the clocks will go back an hour on Sunday 30 October. Thank you for your help. The pendulum provides the ability to regulate and adjust the time keeping. At that time, you'll need to set your clocks back (remember "fall back") one hour. Thank you. DO NOT lift up on the weights as this could cause the weights to come unhooked from the chains. Put the hour hand back on pointing to the hour number that matches the number of hours that the . This image may not be used by other entities without the express written consent of wikiHow, Inc.
\n<\/p>

\n<\/p><\/div>"}, {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/1\/13\/Set-a-Grandfather-Clock-Step-7.jpg\/v4-460px-Set-a-Grandfather-Clock-Step-7.jpg","bigUrl":"\/images\/thumb\/1\/13\/Set-a-Grandfather-Clock-Step-7.jpg\/aid11259482-v4-728px-Set-a-Grandfather-Clock-Step-7.jpg","smallWidth":460,"smallHeight":345,"bigWidth":728,"bigHeight":546,"licensing":"